Product Overview
The BF10W produces an inviting atmospheric warmth quickly and efficiently. The BF-10W is equipped with a hydraulic thermostat and a constant 10,000 BTU input. The hydraulic thermostat allows you to turn the unit on and let the thermostat cycle the heat. It features top mounted control knobs and a push button igniter system that lights the pilot without matches. Since it is a gas heater, it will operate in the event of a power failure. There is an optional blower (SRB18TW) available for this unit, however the blower will not operate during a power outage. Also available is a floor stand (SRS18W) as an alternative to wall mounting.
Vent-Free Products are intended to be used as a supplemental or secondary heat source. If window condensation problems are common in your home, installing a vent-free heater may not be a good option for you.
- Test-fired in the factory
- Oxygen-Depletion Sensor shuts off the unit if there is not enough available fresh air
- Updated White Finish
- Durable, scratch-resistant finish
- Gas heat is less expensive to operate versus electricity
- 99.9% AFUE Efficiency Rating
This appliance may be installed in an aftermarket manufactured (mobile) home, where not prohibited by state or local codes.
Available in Natural Gas BF-10WN and Liquid Propane BF10WL
A licensed gas technician is required for installation of this product. Please check your local regulations as some areas may require inspection after installation of gas products. It is highly recommended that you use your own gas technician or gas provider for any repairs.
PHOTO SHOWS HEATER MOUNTED ON OPTIONAL FLOOR STAND.
Vent-Free Products Cannot Be Shipped To The State Of California.
Tech Specs
General Features
System Data
Gas Requirements
Clearances
Weights and Dimensions
Electrical Requirements
California residents see Prop 65 WARNINGS
WARNING!
Warning: Cancer and Reproductive Harm - www.p65warnings.ca.gov
