Williams Furnace Company 350292A 35,000 BTU Vented Hearth Heater with Fireplace Front and Factory Installed Blower

Adding a focal point to your room, while also adding heat is easy with the fireplace front of the Williams Vented Hearth Heater. With 35000 BTUs, this heater vents outside and heat is dispersed through the louvered top and front grille for optimum circulation.​

 

It is ideal for hard-to-heat areas in homes, apartments, offices, schools, and more. Because it is a gas heater, it is less expensive to operate than electric heat and it will heat even if you lose power. A blower is available separately for this heater. Electricity is required when adding the blower to your unit. A blower increases the circulation of your warm air for better distribution of heat. If a blower is installed in this unit, the blower will not operate during a power failure.

 

All wiring and controls are easily accessible from the front of the unit.

 

This heater is available in Natural Gas (3502922A) and Liquid Propane (3502921A). An factory installed blower comes with this heater. It is also available without a blower (blower sold separately) to install yourself. Please select your options such as a high elevation kit (if you are 2001 ft. or more above sea level), and a thermostat at the time of purchase. 

• No electricity required (without blower)
• 4" Vent size
• Burners engineered for quiet ignition and maximum heat efficiency
• Louvered-top design and front grille for improved heat circulation
• Resettable vent switch
• Convertible gas valves
• Must be installed against a wall (minimum 6" clearance to the rear and 6" from side wall) and vented to the outside
• Features stunning "fireplace front" design
• Read owner's manual before installing/operating
• Check local codes and ordinances for permitted uses
• Servicing recommended by qualified service technician